{}
The LRD43xx type of thermal overload relays are directly mounted to the contactors LC1D115 & LC1D150 only. There is no separate mounting kit for the LRD43xx. If a separate mounting is required...
The Temperature Thresholds at which the Cooling Fan of Altistart 48 Soft Starter start and stop is controlled are as follows: 1. Start – Heatsink Temperature > 50°C. 2. Stop – Heatsink Temperature...
The Steel sheet metal thickness used in Okken switchboard is as listed below: Okken Steel sheet metal thickness Housing Thickness mm Door 2.00mm Rear panels 1.50mm Side panels 1.50mm Roof 1.50mm...
The material composition used in the Main Bus Bar of the Masterpact Air Circuit breaker (ACB) is shown in the table attached. Note: AL/Sn5 means Aluminum connector with Sn5 coated
The selection should be done after derating the Circuit Breaker taking into consideration voltage variation and capacitors tolerances that could increase nominal current up to 1.5In. The Derating...
TSXSCPCM4030 cable is required from TSXSCP114 PCMCIA card to the Modbus branching device TSXSCA50 for connecting other RS485 device on the Modbus Network. In case TSXSCA50 Modbus branching device is...
